Marantz Speaker SW7001 User Manual

Model SW7001 User Guide  
Subwoofer  
 
Thank you for purchasing the Marantz SW7001 Subwoofer.  
BEFORE USING  
Before using this unit, please read the User Guide carefully to ensure  
proper operation of the unit, and retain it together with the supplied  
warranty.  
This section must be read before any  
connection is made to the mains supply.  
To ensure proper heat radiation, ensure  
the below clearance from walls and other  
equipment.  
7 Equipment mains working  
7 Accessories Check  
Rear 4 ins. (0.1 m) or more  
setting  
Before use, check the below accessories were included in the package.  
Your Marantz product has been prepared to  
comply with the household power and safety  
requirements that exist in your area.  
• Audio cable  
• Remote control cable  
• User Guide (This manual)  
This unit can be powered by 120V AC only.  
• Warranty Card  
(USA x 1, Canada x 1)  
7 Copyright  
Recording and playback of any material may  
require consent. For further information refer  
to the following:  
7 Keep Objects Off  
Keep objects off the unit.  
– Copyright Act 1956  
– Dramatic and Musical Performers Act  
1958  
CONTENTS  
7 Do not touch hot spots during  
and immediately after use  
– Performers Protection Acts 1963 and 1972  
BEFORE USING .......................................................................................... 1  
During and immediately after use, the unit  
is hot in areas other than the controls and  
rear panel connection jacks. Do not touch hot  
spots and especially the rear panel. Contact  
with hot areas can cause burns.  
– Any subsequent statutory enactments and  
orders  
NAMES AND FUNCTIONS OF PARTS....................................................... 2  
FRONT PANEL.................................................................................................... 2  
FRONT PANEL.................................................................................................... 2  
7 Do Not Locate in the Following  
CONNECTIONS........................................................................................... 3  
INSTALLATION............................................................................................ 3  
SPECIFICATIONS ....................................................................................... 4  
OTHERS ...................................................................................................... 4  
Places  
To ensure long-lasting use, do not locate the  
unit where:  
7 Cautions on handling power  
cord  
• Exposed to direct sunlight.  
• Near to sources of heat such as heaters.  
• Highly humid or poorly ventilated.  
• Dusty.  
• Do not touch the power cord with wet  
hands.  
• When disconnecting the power cord,  
always make sure that you take hold of the  
plug. Yanking out or bending the cord can  
damage it and/or cause electric shocks or  
a fire.  
• Subjected to mechanical vibrations.  
• On wobbly, inclined or otherwise unstable  
surfaces  
• Get into the habit of disconnecting the  
power plug before leaving home.  
• On a high place such as on a TV set  
1
 
NAMES AND FUNCTIONS OF PARTS  
w STANDBY indicator  
r INPUT jack  
FRONT PANEL  
REAR PANEL  
This indicator shows the status of the  
unit’s power.  
The indicator lights in green when the unit  
is turned on.  
This is an audio input jack used to connect  
to the subwoofer output jack of the optional  
ES7001 or a commercially available AV  
amplifier.  
INPUT CONTROL IN  
MODEL NO.. SW7001  
It lights in red when the unit is in standby  
mode.  
AC OUTLETS  
t CONTROL IN jack  
This is a control signal input jack used to  
connect to the SUB W. CONTROL OUT  
jack on the optional ES7001.  
In conjunction with the power on/off on the  
ES7001, this unit is turned on/off.  
Note:  
The power consumption in standby  
mode is approximately 0.5 W. We  
recommend you turn off the unit when  
it is not in use.  
UNSWITCHEDD 350W MAX  
120V 60Hz  
AC IN  
Note:  
POWER ON/STANDBY  
+
VOLUME  
e VOLUME -/+ knob  
Connection with any equipment other  
than the ES7001 may cause damage  
to the unit.  
This knob is used to adjust the volume.  
Turning it clockwise increases the volume.  
q w  
e
rty u  
y AC OUTLET  
q POWER ON/STANDBY button  
Notes:  
These AC outlets supply power to the  
optional ES7001, DVD player, etc.  
Setting the volume of the connected  
amplifier to an excessively high level  
may cause sound deterioration or  
damage to the unit. Please note the  
following when you use the unit with an  
amplifier connected.  
This button is used to switch between  
power-on and standby mode. When the  
unit is turned on and no audio signal is  
input for several minutes, the unit’s auto  
power-on/standby-function is activated  
and the unit automatically goes into  
standby mode.  
When the CONTROL IN jack of the unit is  
connected to the SUB W. CONTROL OUT  
jack of the ES7001 HomeTheater System,  
this unit is turned on or goes into standby  
mode in conjunction with the operations of  
the ES7001.  
• The AC outlets are capable of supplying  
power even if the unit’s power is turned  
off.  
• The AC outlets are capable of supplying  
power to audio equipment which  
requires a total power consumption of  
up to 350 W.  
• Do not set the unit’s volume too high  
when the bass level is excessively  
increased with the tone or loudness  
controls on the connected amplifier.  
Note:  
Never connect a TV set, electric cleaner,  
hair dryer, etc.to these AC outlets.Doing  
so may cause damage to the unit.  
• Set the volume control of the  
connected amplifier to the minimum  
level when you switch on the  
amplifier’s power.  
u AC power cord  
Note:  
The unit’s auto-power-on/standby  
function is available only when the  
control connection is made with the  
ES7001.  
Connect to a wall outlet capable of  
supplying AC 120 V 60 Hz.  
2
 
CONNECTIONS  
INSTALLATION  
• Use the connecting cables supplied with this unit when connecting with the ES7001 Home Theater System.  
Notes:  
• If the unit is turned on after connection with the ES7001, the unit goes into standby mode or turns on in conjunction with operation of the  
ES7001. (Subwoofers of other manufacturers do not work in conjunction with the ES7001.)  
• Install the unit near the wall outlet so that  
the AC power cord is easily disconnected.  
• The unit is not disconnected from the AC  
power source even if the unit is turned off.  
To disconnect it from the AC power source  
completely, unplug the unit from the wall  
outlet.  
Notes:  
Do not connect the AC power cord of the unit to the wall outlet before making all connections.  
• Insert all connecting cable plugs firmly into the connectors. A loose connection may result in no sound or noise.  
• Be sure to unplug the unit when connecting or disconnecting the cables. Connecting or disconnecting the cables without unplugging may cause  
a malfunction or breakdown of the unit.  
7Unit’s anti-magnetism and  
7Connecting the unit  
interference with a TV picture  
This unit is an anti-magnetic type subwoofer,  
but if the unit is located near a TV, the colors  
may become spotty. If this occurs, place the  
unit further away from the TV.  
• Connect the INPUT jack on this unit to the SUB W. PREOUT jack on the ES7001.  
• Connect the CONTROL IN jack on this unit to the SUB W. CONTROL OUT jack on the ES7001.  
7Howling  
When the unit is placed near an analog record  
player, the output sound from the unit may  
cause the installation surface and ambient air  
to vibrate, producing howling. If this happens,  
install the unit further away from the analog  
record player or decrease the volume level of  
the unit.  
INPUT CONTROL IN  
MODEL NO. SSW7001  
AC OUTTLETS  
In rare cases, howling may occur with a VCR,  
compact disc player, mini-disc player or DVD  
player and result in deterioration of sound  
and picture. In this case, place the unit further  
away from the equipment or decrease the  
volume.  
SUB W. PREOUT  
UNSWITCHEED 350W MAX  
120V 60Hz  
AC IN  
SUB W.  
CONTROL OUT  
Rear of SW7001  
Right side of ES7001  
3
 
SPECIFICATIONS  
OTHERS  
The section describes the care and  
maintenance tasks that must be performed  
to optimize the operation of your Marantz  
component.  
Power amplifier section  
Dimensions / Mass  
7 Repairs  
Rated output...........50 W (EIAJ 100 Hz, 4 Ω)  
Line input sensitivity ...........................220mV  
Frequency characteristics..........38Hz–170Hz  
Width .............................. 231 mm (9-1/8 ins.)  
Height ....................................203 mm (8 ins.)  
Depth.......................... 312 mm (12-5/16 ins.)  
Mass ....................................6.2 kg (13.7 lbs)  
Only the most competent and qualified  
service technicians should be allowed to  
service the factory-trained warranty station  
personnel have the knowledge and special  
facilities needed for repair and calibration of  
this precision equipment. After the warranty  
period has expired, repairs will be performed  
for a charge if the equipment can be returned  
to normal operation.  
Speakers  
7 Cleaningofequipmentexternal  
Enclosure.............................. bass reflex type  
Speaker unit ................................16 cm cone  
Rated impedance .....................................4 Ω  
Supplied accessories  
surfaces  
Audio cable.................................................. 1  
Remote control cable................................... 1  
User Guide (this manual)............................. 1  
Warranty card (USA x 1, CANADA x 1)....... 1  
The exterior finish of your unit will last  
indefinitely with proper care and cleaning,  
Neverusescouringpads,steelwool,scourging  
powders or harsh chemical agents (e.g., lye  
solution), alcohol, thinner, benzine, insecticide  
or other volatile substances as these wil mar  
the finish of the equipment. Likewise, never  
use cloths containing chemical substances.  
If the equipment get dirty, wipe the external  
surfaces with a soft, lint-free cloth.  
Power supply  
In the event of difficulty, refer to your dealer or  
write directly to the nearest location to you that  
is listed on the Marantz Authorized Service  
Station list. If writing, please include the model  
and serial number of the equipment together  
with a full description of what you think is  
abnormal about the equipment’s behaviour.  
Power requirements..............AC 120 V 60 Hz  
Rated power consumption..................... 60 W  
Power consumption in standby mode... 0.5 W  
Note:  
The speaker nets cannot be removed.  
Dimensions  
312 (12-5/16)  
7
302 (11-15/16)  
3
(1/8)  
231 (9-1/8)  
(5/16)  
If the equipment becomes heavily soiled:  
• dilute some washing up liquid in water, in  
a ratio of one part detergent to six parts  
water.  
• dip a soft, lint free in the solution and wring  
the it is damp.  
• wipe the equipment with the damp cloth.  
• dry the equipment by wiping it with a dry  
cloth.  
Unit:mm (inch)  
Specifications subject to change without prior notice.  
4
 
You can find your nearest authorized distributor or dealer on our website.  
is a registered trademark.  
Printed in Malaysia  
07/2007 00M38CW851250 mzh-d  
 

Kuppersbusch USA Cooktop GMS 9551 User Manual
KVH Industries Satellite TV System eTrac User Manual
Kyocera Cell Phone QCP 2035 User Manual
LA Audio Electronic Stereo Amplifier UB282 User Manual
LG Electronics CRT Television 29FX6ALX User Manual
Liebherr Refrigerator 7082 246 00 User Manual
LOREX Technology Network Card DHU500 SERIES User Manual
Marvel Industries Refrigerator 8SBARE User Manual
Maytag Clothes Dryer W10239302B User Manual
Memorex MP3 Player MDF1062 MTL User Manual